Products › Dante Routing plugin
Dante Routing plugin
Route Dante audio from Q-SYS – a routing matrix like Dante Controller, with presets and protect
$19.90 per Q-SYS Core, excl. tax. Pay by card, get the license key instantly. Every MLST plugin also runs as a full-featured 30-minute demo each time the design starts.
Dante routing straight from Q-SYS
MLST’s Dante Routing plugin lets you patch Dante audio from Q-SYS – in the design, from a UCI or remotely – without opening Dante Controller. The plugin finds the Dante devices on the network by itself and shows a routing matrix that works the way Dante Controller does.
Features
- Routing matrix like Dante Controller: devices fold out and in, filters for transmitters and receivers, scroll bars, tree lines and short channel names
- Click a crosspoint to subscribe, click again to remove – the change is sent straight to the Dante device
- Signal level per channel, read from the Dante heartbeats
- Status page: every device with IP address and subscription state (unresolved, clock domain mismatch and other Dante errors)
- Presets: save and recall the routing of all devices or one device, as plain text that can be copied between projects
- Protect: puts routes back if they are changed in Dante Controller or lost when a device restarts
- Fault pins for alarms and notifications, and a Command pin for routing from scripts and snapshots
- Finds devices with mDNS, Dante heartbeats and a search of the local network; devices on other subnets can be added by IP address
Requirements
- Q-SYS Designer and a Q-SYS Core on the same network as the Dante devices (Dante primary network)
- The plugin changes routing only. Clocking, latency, channel names, AES67 and device settings are left as they are.
- Full function in Emulate. On a Core the plugin needs a license; without one it shows the routing but does not change it.
Independently developed by MLST. This product is not affiliated with or endorsed by Audinate or Q-SYS. Dante is a trademark of Audinate. Trademarks are used solely to describe compatibility.
Compatibility and requirements
- Q-SYS: Q-SYS Designer 10.x and a Q-SYS Core (tested in Designer 10 Emulate)
- Dante devices: Tested with Q-SYS Core Software Dante and Dante AVIO adapters
- Network: Core on the Dante primary network. Uses UDP 4440 (Dante control), 5353 (mDNS) and 8708 (Dante heartbeats)
- Not supported: Devices managed by Dante Domain Manager, receive channels above 255
- License: One license per Q-SYS Core (Locking ID)
Buying a license
Each license is tied to one Q-SYS Core through its Locking ID (find it in Q-SYS Core Manager under Licensing). If you replace the Core, you can move the license to the new one yourself (once) under My licenses.